Noise Handling Pada Sinyal Seismik Menggunakan Fourier Transform

Authors

DOI:

https://doi.org/10.34818/eoe.v7i2.12360

Abstract

Abstrak Sinyal seismik adalah rambatan energi yang biasanya disebabkan oleh gangguan dari dalam bumi atau kerak bumi. Alat untuk mendapatkan informasi sinyal seismik adalah seismometer, sinyal seismik memiliki informasi berupa kekuatan gempa yang tercatat, dan juga ada yang tidak termasuk informasi pada sinyal seismik berupa noise. Noise ini sangat merugikan informasi yang lainnya, oleh karena itu akan dilakukan penelitian untuk mereduksi noise pada sinyal seismik dengan sistem noise handling. Sistem ini akan mengatasi noise pada sinyal seismik, dan akan menghasilkan sinyal seismik dengan noise yang sudah direduksi. Penelitian sistem noise handling ini bertujuan untuk mereduksi adanya noise pada sinyal seismik, dan membuat sinyal seismik menghasilkan informasi yang dibutuhkan dengan benar dan akurat. Noise handling akan mengatasi permasalahan tersebut dengan teknik frequency analysis yaitu menggunakan metode fast fourier transform dan filtering. Sistem ini akan mengolah data sinyal seismik dari beberapa event gempa bumi, dan akan menghasilkan sinyal seismik dengan noise yang sudah direduksi. Dalam penelitian ini, perfomansi terbaik dalam pengujian untuk sistem noise handling menggunakan metode fast fourier trasnform dengan nilai low pass filter = 0.1 dan high pass filter = 0.1, mendapatkan nilai SNR = 46.44886478 dan MSE = 0.849324382. Kata Kunci : Noise Handling, Seismic Signal, Fast Fourier Transform, SNR, MSE, Frequency Analysis Abstract Seismic signals are the energy vines that are usually caused by interference from the earth or Earth's crust. The tool to obtain seismic signal information is a seisthermometer, the seismic signal has information in the form of earthquake strength recorded, and also some do not include information on seismic signal in the form of noise. This noise is detrimental to other information, therefore it will be done research to reduce noise in seismic signal with noise handling system. This system will address noise in the seismic signal, and will result in a seismic signal with reduced noise. The research of this noise handling system aims to reduce the presence of noise in seismic signals, and to make seismic signals deliver the required information correctly and accurately. Noise handling will overcome the problem with the frequency analysis technique using the fast Fourier transform and filtering methods. The system will process seismic signal data from several earthquake events, and will result in a seismic signal with reduced noise. In this study, the best perfomance in testing for noise handling systems using fast Fourier Trasnform method with low pass filter value = 0.1 and high pass filter = 0.1, get SNR value = 46.44886478 and MSE = 0.849324382. Keywords: Noise Handling, Seismic Signal, Fast Fourier Transform, SNR, MSE, Frequency Analysis

Downloads

Download data is not yet available.

References

[1] T. Perol, M. Gharbi, and M. Denolle, “Convolutional neural network for earthquake detection and location,” Sci. Adv., vol. 4, no. 2, 2018.

[2] J. O. Parra, C. L. Hackert, and S. Antonio, “Frequency slice filtering – a novel method of seismic noise attenuation,” Technology, pp. 32–35, 2002.

[3] I. P. Noise and A. Algoritma, “Implementasi Pengurangan Noise ... (Sriyanto dan Sipayung),” no. 1964, pp. 6–11, 2016.

[4] H. Magsi, A. H. Sodhro, F. A. Chachar, and S. A. K. Abro, “Analysis of signal noise reduction by using filters,” 2018 Int. Conf. Comput. Math. Eng. Technol. Inven. Innov. Integr. Socioecon. Dev. iCoMET 2018 - Proc., vol. 2018-Janua, pp. 1–6, 2018.

[5] Sunarjo, M. T. Gunawan, and S. Pribadi, Gempabumi Edisi Populer. 2012.

[6] W. Li, N. Narvekar, N. Nakshatra, N. Raut, B. Sirkeci, and J. Gao, “Seismic data classification using machine learning,” Proc. - IEEE 4th Int. Conf. Big Data Comput. Serv. Appl. BigDataService 2018, no. July, pp. 56–63, 2018.

[7] Z. E. Ross, M. A. Meier, E. Hauksson, and T. H. Heaton, “Generalized seismic phase detection with deep learning,” Bull. Seismol. Soc. Am., vol. 108, no. 5, pp. 2894–2901, 2018.

[8] F. Roy, “Detection and identification of seismic signals using artificial neural networks,” Curr. Sci., vol. 74, no. 1, pp. 47–54, 1998.

[9] I. Conference and C. Technology, “Implementation of Automatic First Arrival Picking On P-Wave Seismic Signal Using Logistic Regression Method,” pp. 134–138, 2020.

[10] M. Bagheri and M. A. Riahi, “Using a Novel Method for Attenuating Random Noises from Seismic Data,” vol. 7, no. 3, pp. 65–72, 2018.

[11] M. Wahyu and P. Indi, “Automatic First Arrival Picking on P-Wave Seismic Signal Using Support Vector Machine Method,” pp. 128–133, 2020.

[12] XX, “California Integrated Seismic Network (CISN),” New Man. Seismol. Obs. Pract., no. June, p. XX, 2012.

[13] N. Chittora and D. Babel, “a Brief Study on Fourier Transform and Its Applications,” vol. 05, no. 12, pp. 1127–1131, 2018.

[14] H. R. Taylor, Book Review: The Fast Fourier Transform and its Applications, vol. 27, no. 3. 1990.

[15] H. Sujadi, I. Sopiandi, and A. Mutaqin, “Sistem Pengolahan Suara Menggunakan Algoritma FFT (Fast Fourier Transform),” Sintak, pp. 101–107, 2017.

[16] A. L. Prasasti, “Perancangan Filter Analog Multistep pada Photoplethysmograph untuk Mengamati Detak Jantung Manusia Menggunakan Arduino,” vol. 17, no. 2, pp. 237–248, 2016.

[17] A. Digital, S. Line, K. Adsl, N. Adsl, N. Ratio, and N. Ratio, “3) 1,2,3,” vol. 2, no. November, pp. 1–11, 2010.

[18] K. Margi S and S. Pendawa W, “Analisa Dan Penerapan Metode Single Exponential Smoothing Untuk Prediksi Penjualan Pada Periode Tertentu,” Pros. SNATIF, no. 1998, pp. 259–266, 2015.

Downloads

Published

2020-08-01

Issue

Pages

4699-4710

Section

Program Studi S1 Teknik Komputer

How to Cite

Pratama, Y. A., Novianty, A., & Prasasti, A. L. (2020). Noise Handling Pada Sinyal Seismik Menggunakan Fourier Transform. EProceedings of Engineering, 7(2), 4699-4710. https://doi.org/10.34818/eoe.v7i2.12360