Analisis Pengaruh Luas Penampang Elektroda Terdistribusi Terhadap Karakteristik Arus Dan Tegangan Pada Sel Tunam Mikroba
DOI:
https://doi.org/10.34818/eoe.v7i2.12251Abstract
Abstrak Sel Tunam Mikroba (STM) merupakan salah satu energi terbarukan yang dapat menghasilkan energi listrik dengan metode bio-elektrokimia, yang mengkonversi energi kimia menjadi energi listrik dengan memanfaatkan metabolisme alami dari mikroba. Elektroda pada kompartemen anoda dan katoda menggunakan pelat logam dari berberapa jenis material seperti tembaga dan seng. Reaktor pada STM ini menggunakan skema single chamber memiliki satu ruang yang berisi substrat dan larutan elektrolit. Kompartemen anoda berwujud di lingkungan terbuka dengan empat bagian yang dilengkapi dengan pelat elektroda yang terdistribusi menjadi empat bagian dengan masing-masing dimensi 5 cm × 2 cm dan mengelilingi kompartemen katoda, sedangkan pada kompartemen katoda berbentuk tabung yang memiliki diameter 10 cm dan tinggi 15 cm. Kedua kompartemen tersebut dihubungkan oleh jembatan garam. Penelitian ini dilakukan dengan tujuan untuk mengetahui pengaruh luas penampang elektroda terdistribusi terhadap karakteristik arus dan tegangan pada sel tunam mikroba. Selain itu untuk mengetahui pengaruh luas penampang dan jumlah elektroda terhadap produksi listrik yang dihasilkan. Kata kunci : Sel Tunam Mikroba, Elektroda, Karakteristik Arus dan Tegangan Abstract The need for energy in the world will increase by the time, we cannot just rely on fossil energy because its existence will run out in the near future. The use of energy from biomass is the solution. Microbial Fuel Cell (MFC) is one of the solutions to biomass energy utilization. In this study, the design of the MFC aim to produce electricity is more constant. Semi-continuous system becomes a solution for electricity that is relatively constant compared with using a batch-substrate system. The construction of MFC uses a double chamber system consisting of a cathode compartment with Cu electrodes and anode compartment using Zn electrodes and substrate prepared by a fish pond sediment and spoiled rice. In building the system, semi-continuous MFC’s can be approved using a dispenser-like container to facilitate substrate entering into the system. After the reactor is made, the voltage can be read by the data logger or using a multimeter. the result of a semi-continuous MFC reactor process is a graph of voltage output compared to the time spent stable. the results of the semi- continuous MFC reactor is a voltage output graph compared to a time that is close to stable where the value of the variance in the reactor with the addition of 75ml every three days has the closest value to zero which means the most stable. The variance value at the most stable reactor has a variance value of 0.00159 with average of voltage is 0.648V. Keywords: Microbial Tunam Cell, Distributed Electrodes, Current and Voltage Characteristics.Downloads
References
[1] Badan Pengkajian dan Penerapan Teknologi. (2018). Outlook Energi Indonesia 2018. Jakarta: Pusat Teknologi Pengembangan Sumberdaya Energi BPPT.
[2] Kementerian Energi dan Sumber Daya Mineral. Statistik Ketenagalistrikan 2018. Jakarta. Edisi No. 31 Tahun Anggaran 2018.
[3] Blueprint Pengelolaan Energi Nasional 2010-2025 dan Kebijakan Energi Nasional (KEN) dalam Peraturan Pemerintah No. 79 tahun 2014
[4] Hasan, Achmad, “Aplikasi Sistem Fuel Cell Sebagai Energi Ramah Lingkungan di Sektor Transportasi dan Pembangkit” Peneliti di Pusat Teknologi Konservasi Energi. Vol. 8 No. 3, September 2013, hal. 277-286.
[5] Korneel Rabaey Korneel, Guez Rodrı Jorge, Linda L Blackall, Kellen Jurg, Gross Pamela, Batstone Damien, Verstraete Willy, and Nealson H Kenneth. (2007). Microbial ecology meets electrochemistry: electricity-driven and driving communities, Department of Earth Sciences, University of Southern California, Los Angeles, CA, USA.
[6] Li, Jessica. An Experimental study of Microbial Fuel Cell for Electricity Generating: Perfomance Characterization and Capacity Improvement. Journal of Sustainable Bioenergy Systems, 3, 171-178, Agustus. 2013.
[7] Logan, B. E. Microbial Fuel Cells. New Jersey: John & Wiley Inc. 2008
[8] Logan, B. E. “Microbial Fuel Cells” Metodhology and Technology. Enviromental Science and Technology, 40. 2006.
[9] Ashoka, H., R, S., & Bhat, P. (2012). Comparative Studies On Electrodes For The Construction Of Microbial Fuel Cell. International Journal of Advanced Biotechnology and Research, 3, 785-789.
[10] Akbar Nuzul T. (2017). Analisis pengaruh material logam sebagai elektroda Microbial Fuel Cell terhadap produksi energi listrik. Fakultas Teknik Elektro Program Studi Teknik Fisika Telkom University, Bandung.
[11] Chang, R. Kimia Dasar: Konsep-Konsep Inti (3rd ed.). Jakarta: Erlangga. 2005
[12] Logan, B. E. Microbial Fuel Cells: Metodhology and Technology. Enviromental Science and Technology, 40. 2006.
[13] Chang, R. Chemistry (10th ed.). New York: The McGraw-Hill Companies, Inc. 2010
[14] Purba, M. Kimia SMA/MA Kelas XII. Jakarta: Erlangga. 2007.
[15] Singh, D. (2010). Microbal Fuel Cells: A Green Technology for Power Generation. Scholars Research Library, 3, 128-138.
[16] Monier, J. M. (2008). Microbial Fuel Cell: From Biomass (waste) to Electricity.ResearchGate
[17] Logan, B. E. (2008). Microbial Fuel Cells. New Jersey: John & Wiley Inc.



