Perancangan Dan Realisasi Pandu Gelombang Persegi Panjang Pada Frekuensi 2,4 Ghz Dengan Menggunakan 3d Printing

Authors

[1] M. D. Auria et al., “3-D Printed Metal-Pipe Rectangular Waveguides,” pp. 1–11, 2015.

[2] G. P. Le Sage, “3D Printed Waveguide Slot Array Antennas,” IEEE Access, vol. 4, pp. 1258–1265, 2016,

doi: 10.1109/ACCESS.2016.2544278.

[3] P. Antena, “Design and Realization of Double-Ridged Horn Antenna for Standard Antenna,” vol. 4, no. 3,

2018.

[4] J. Weiner, F. Nunes, J. Weiner, and F. Nunes, “Transmission Lines and Waveguides,” Light. Interact., pp.

154–210, 2017, doi: 10.1093/acprof:oso/9780198796664.003.0008.

[5] M. Q. Khairuzzaman, Pozar. Microwave Engineering, vol. 4, no. 1. 2016.

[6] C. Guo et al., “A 3-D Printed E-Plane Waveguide Magic-T Using Air-Filled Coax-to-Waveguide

Transitions,” IEEE Trans. Microw. Theory Tech., vol. 67, no. 12, pp. 4984–4994, 2019, doi:

10.1109/TMTT.2019.2944355.

[7] M. R. Hidayat, A. Poetra, T. Elekro, U. Jenderal, and A. Yani, “Purwarupa Mode Konverter Rectangular

Waveguide Menggunakan Double-Trench,” vol. 19, no. 01, pp. 53–59, 2020.

[8] D. H. Whittum, “Introduction to Microwave Linacs,” Tech. Concepts High Energy Phys. X, no. January

1999, pp. 387–486, 1999, doi: 10.1007/978-94-011-4689-0_11.

[9] O. A. Saputra, Pengoperasian Mesin Cetak 3D, no. December. 2019.

[10] F. D. Quesada Pereira, J. L. Gómez Tornero, D. Cañete Rebenaque, J. Pascual García, and A. Alvarez

Melcón, “Wire and patch method of moments models of coaxial to arbitrary waveguide transitions,” IEEE

Antennas Propag. Soc. AP-S Int. Symp., vol. 3 B, no. August, pp. 251–254, 2005, doi:

10.1109/APS.2005.1552485.

[11] P. N. Laina, “Design of a rectangular waveguide connected biosensor for frequencies from 220 to 1100

GHz,” 2015.

[12] S. Results, “Design and Test of a 3D Printed Horn Antenna Design and Test of a 3D Printed Horn

Antenna,” pp. 14–17, 2015.

[13] P. M. Plastic and H. T. Reliability, “RF / Microwave High-Reliability,” vol. 45, no. 2, 2018.